Instructions / Assembly

5. Optional for additional support or necessary
where there is no element to rest on plastic
spacers:
Slide or
snap brackets
into groove
on bottom of
front panel.
6. Position new
assembled cover
with wall brackets
below element,
then slip new cover
over back panel.
7.
Optional:
Screw brackets
to existing back
panel with
supplied
self-drilling
screws.
8. Attach end caps, corner pieces or chosen
accessories as required.
PREPARE EXISTING BASEBOARD
1 Remove old end caps.
2. Remove existing front panel.
3. Remove any existing damper sections.
PREPARE NEW ALUMINUM COVER
4. Set plastic cover spacers on top of
heating element
Quick Installation Guide
Appropriate gloves and eye protection should be worn during installation. For Use With Hydronic Baseboard Only!
Video Installation Intructions
You can watch a demonstration video of how
to install your new Revital/Line Replacement
Cover at
www.slantfin.com
RVTL-E-40 • 1217