User's Manual

ManualsBrandsSlant/Fin ManualsBoilersSlant/Fin VHS-90

User’s Information Manual

FOR YOUR SAFETY:

• Before operating this boiler, READ this manual.

• DO NOT attempt to install, service or repair this boiler yourself. There are no user serviceable parts.

Contact a qualified service agency if your boiler needs repair or maintenance. Ask your gas supplier

for a list of qualified service agencies.

• A qualified service agency should inspect the venting system of this boiler on an annual basis.

— DO NOT store or use gasoline or

other flammable vapors and liquids in

the vicinity of this or any other

appliance.

— WHAT TO DO IF YOU SMELL GAS

• DO NOT try to light any appliance.

• DO NOT touch any electrical switch.

DO NOT use any phone in your

building.

• Immediately call your gas supplier

from a neighbor's phone. Follow the

gas supplier's instructions.

• If you cannot reach your gas supplier,

call the fire department.

— Installation and service must be per-

ormed by a qualified installer, service

agency or the gas supplier.

WARNING: If the information in this

manual is not followed exactly, a fire

or explosion may result causing

property damage, personal injury or

loss of life.

Your gas boiler must be installed and serviced by a qualified service agency or

gas supplier. The lack of proper service can result in a dangerous condition.

PUBLICATION NO. VHS-UIM

t No

44-0832

Printed in U.S.A. 106

Residential • Gas-fired • Hot Water Boilers

VICTORY

™

II GAS BOILERS – VHS MODELS

This manual must be left with owner, hung on

or adjacent to the boiler. Owner should retain

manual for future reference.

VHS Models with Intermittent Pilot System – Spark Ignition

Summary of content (8 pages)

PAGE 1
Residential • Gas-fired • Hot Water Boilers User’s Information Manual VICTORY™ II GAS BOILERS – VHS MODELS VHS Models with Intermittent Pilot System – Spark Ignition FOR YOUR SAFETY: • Before operating this boiler, READ this manual. • DO NOT attempt to install, service or repair this boiler yourself. There are no user serviceable parts. Contact a qualified service agency if your boiler needs repair or maintenance. Ask your gas supplier for a list of qualified service agencies.
PAGE 2
VICTORY II VHS MODELS Pressure relief valve Blower assembly Adapter and condensation drain Air flow proving switch Aquastat Ignition control Inducer relay Junction box Circulator Gas valve Condensation trap Figure 1.
PAGE 3
VICTORY II VHS MODELS INSPECTION Your boiler and heating system will last an indefinitely long time at full efficiency, if it is inspected regularly and is kept in good repair and adjustment. You, the user, should make regular inspections, and report any problems to your service agency. At regular intervals, you should have that agency inspect the system, clean the boiler and make repair adjustments as necessary. What you and the service agency should do is listed below.
PAGE 4
VICTORY II Figure 4. Vertical venting through chimney VHS MODELS 2. Condensation drain trap inspection Check condensation drain trap to be full of water. Check for deterioration of the tubing. Check that trap is not plugged. DO NOT operate the boiler without filling the trap with water to prevent flue gas discharge into space. The drain should extend to a floor drain or to a container which may require emptying periodically. 3. Piping inspection Look at all water piping.
PAGE 5
VICTORY II VHS MODELS Figure 6. Figure 7. DO NOT use open flame. 3. Condensation drain trap inspection See page 4 for instruction. 4. Piping inspection Check the following: A. Water piping and accessories for leaks. Slightest leaks should be corrected. B. System to be full of water and pressure to remain stable at correct setting on gauge. C. Air-control system. Noise and air binding in radiation should not occur. D. Low water cutoff for operation (see instructions furnished with unit). E.
PAGE 6
VICTORY II Remove jacket top. Remove inducer assembly. Remove flue collector. Use wire brush to clean flue passages. Replace flue collector and re-seal with furnace cement. 7. Replace inducer assembly, jacket top and control top. 8. Remove and dispose of paper and accumulated material. 2. 3. 4. 5. 6. VHS MODELS C. Adjust main burners and pilot flames. See “Installation and Operating Instructions”, for instructions. D. Check input gas rate to the burners.
PAGE 7
VICTORY II VHS MODELS C. DO NOT use this appliance if any part has been underwater. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been underwater. Figure 10. Figure 9. OPERATING INSTRUCTIONS 1. STOP! Read the safety information on page 6. 2. Set the thermostat to lowest setting. 3. Turn off all electric power to the appliance. 4.
PAGE 8
SLANT/FIN CORPORATION, Greenvale, N.Y. 11548 • Phone: (516) 484-2600 FAX: (516) 484-5921 • Canada: Slant/Fin LTD/LTEE, Mississauga, Ontario www.slantfin.