User's Manual

3 Program One Remote Control to Two Beds
Before beginning, make certain the beds are plugged into a working,
grounded electrical outlet.
Locate the power down box for bed 1 and press the Learn button on the
power down box for 1 second then release. Press and hold both the Flat
and Raise Head buttons on the first remote simultaneously for more than 5
seconds. The remote LCD display will blink a few times. The LED on the first
power down box will flash slowly at first then rapidly to indicate the remote
has been programmed to operate the first bed.
Repeat these steps with
bed 2. One remote is now programmed to operate two beds.
If programming fails, initiate the programming procedure a
second time.
4 Program Two Remote Controls to Two Beds
Before beginning, make certain the beds are plugged into a working,
grounded electrical outlet.
Locate the power down box for bed 1 and press the Learn button on the power
down box for 1 second then release. Press and hold both the Flat and Raise
Head buttons on the first remote simultaneously for more than 5 seconds. The
remote LCD display will blink a few times. The LED on the first power down box
will flash slowly at first then rapidly to indicate the remote has been programmed
to operate the first bed.
Repeat these steps with remote 2, then locate the power down box for bed
2 and press the Learn button on the power down box for 1 second and re-
lease. Repeat all steps for both remotes on both beds.
If programming fails, initiate the programming procedure a second time.
NOTE: Operate only one (1) remote at a time. Operating two (2) remote at the
same time will momentarily block both RF signals and prevent both remotes
from functioning.
Remote Programming
FLAT
BUTTON
RAISE
HEAD
BUTTON
FLAT
BUTTON
RAISE
HEAD
BUTTON
REMOTE 1
REMOTE 2