Installation Instructions

User instruction
The remote controller being tested is the modulation ASK working mode with a frequency
of 433.935 MHz; two buttons; the remote controller is powered by DC6V (CR2016*2), and
the corresponding device is controlled by RF.
Frequency：433.935MHZ
Working voltage：6V
Working current：4mA±1mA
static current：0uA
Code：EV1527 Main IC:U1
Coding Bandwidth：330us
Oscillation resistance: R2
Key value：Locked 0010、Unlocked 0001
Distance：80m
FCC Statement: This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that
may cause undesired operation. NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures: - Reorient or relocate the receiving
antenna. - Increase the separation between the equipment and receiver. - Connect the
equipment into an outlet on a circuit different from that to which the receiver is
connected. - Consult the dealer or an experienced radio/TV technician for help. WARNING:
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment. The device must
not be co-located or operating in conjunction with any other antenna or transmitter.
Industry Canada statement: This device complies with ISED’s license-exempt RSSs.
Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Le present apparel est.
conformer aux CNR d’ ISED applicable aux apparels’ radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes : (1) le dispositif ne doit
pas produire de brouillage préjudiciable, et (2) ce dispositive doit accepter tout
brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement