User's Manual

iHelmet Hair Growth System (Model: LTD160Pro) User Manual V1.0

NOTE: This manual is only used to operate this electronic device; the company will not bear

the consequences caused by this instruction manual for other purposes and responsibilities.

Without our prior written consent, it should not be allowed to copy any part of this manual or

translation.

Considering the needs of the technical improvement or file update, the company reserves the

right to revise the content in these operating instructions for correction, and if the change does

not involve the sold device safety without prior notice.

Due to technical update or the special requirements of users, under the condition of the

instrument performance is not affected, the standard of some parts is different with this manual,

please pay attention.

Warning: Changes or modifications to this unit not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment.

NOTE：This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may cause undesired

operation.

NOTE：

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

—Consult the dealer or an experienced radio/TV technician for help.

RF exposure compliance statement:

This device has been evaluated to meet the general RF exposure requirement

it can be used in portable exposure condition without restriction.