Installation Guide

ManualsBrandsSlipDoctors ManualsCleaning SuppliesStone Grip- Non-Slip Tile Treatment- Gallon

Surfaces

Color

Mode of Application

Container Size

Application Temperature

Dry Times

Water Resistant

Stain Resistant

Product Type

Coverage

Storage

Shelf Life

Warranty

Removal

Disposal

Coefficient of Friction*

*results may vary depending on

surface and time of exposure

Porcelain, ceramic, terrazzo, quarry, slate, brick, travertine, concrete and many

other stone or mineral surfaces. Porcelain and ceramic bathtubs.

Solution is tinted yellow; will not change the color of floor

Sprayer, microfiber T-mop or Stone Grip Applicator

Quart, gallon (5-gallon pail, 55-gallon drum and 275-gallon tote by special order)

Above 40°F (4°C) surface temperature; evaporation may occur at higher

temperatures.

N/A

Micro-treading solution

Up to 75 sq.ft./quart or up to 400 sq.ft./gallon

50°F (10°C) - 80°F (27°C) Protect from freezing

5 years

2 years

N/A

Dispose of container and unused contents in accordance with local, state,

and federal regulations.

0.62 Wet DCOF - ANSI B101.3

0.65 Wet DCOF - ANSI A137.1 / A326.3

0.72 Wet SCOF - ANSI B101.1

Technical Data Sheet

Special Features

• Interior and exterior use

• Water-based treatment

• Easy to apply

• Increases the coefficient of friction

• Minimal or no appearance change

• One application can last for years

• Low odor

• Immediate use after application

•

Suggested Uses

• Kitchens

• Pool Areas

• Tiled Shower

• Porcelain/Ceramic Bathtubs

• Hotels/Resorts

• Restaurants/Factories

• Hospitals/Nursing homes/Assisted Living

• Health Clubs/Spas

Product Description – Stone Grip is our exclusive anti-slip treatment for porcelain, ceramic and other stone

surfaces. Easy application of this solution creates microscopic treads to increase traction within minutes.

Even when wet, your flooring’s slip resistance after treatment should surpass guidelines by ANSI A137.1 or

B101.3 standards. SlipDoctors Stone Grip can be used on virtually any tile or stone surface and has been

certified for use on floors in and around food processing areas.

SlipDoctors Stone Grip

Product Characteristics and Benefits

Summary of content (3 pages)

PAGE 1
Technical Data Sheet Product Description – Stone Grip is our exclusive anti-slip treatment for porcelain, ceramic and other stone surfaces. Easy application of this solution creates microscopic treads to increase traction within minutes. Even when wet, your flooring’s slip resistance after treatment should surpass guidelines by ANSI A137.1 or B101.3 standards.
PAGE 2
Pag e |2 STONE GRIP TECHNICAL DATA SHEET Directions for Preparation, Application and Use Read entire product label, Technical Data Sheet (TDS) & Safety Data Sheet (SDS) before using. Immediately wash off product if it comes in contact with skin.
PAGE 3
Pag e |3 STONE GRIP TECHNICAL DATA SHEET B. Review Test Results: Once you have achieved an acceptable level of slip resistance and applied the neutralizer, thoroughly rinse and dry the test tile and inspect it carefully to determine if there is any visible change in appearance. If there is a visible change, you can perform another test on a different untreated tile and reduce the treatment time. Continue the testing process as before and inspect the new results.