Instructions / Assembly

inside to inside.
TIPS
If you run into rocks or roots or some other obstruction wile digging your post holes that
may prevent you from centering the posts exactly 8’ apart, you can always make a post
section shorter than 8’ and cut the stringers, then go back to regular 8 foot sections.
NEVER make fence sections between posts longer than 8’ from the
center of two fence-posts as you cannot make the stringers longer than
8 feet.
Repeat this same procedure to set all of the remaining posts required in your fence project.
STEP 4 – Gate Posts
Make sure that Gate-post holes are the same depth and posts are set the same height above
ground as the rest of your fence and approximately 30”-48” apart (or see instructions from
Gate installation guide of gate), and if available use collar style aluminum hardware to fasten
the gate hardware, if collar style is not available use self tapping aluminum gate hardware.
(common lock and pin gate closure), to the 3” aluminum gate posts.
NOTES
If using self tapping hardware such as hinges it is wise to drop a 2 x 3 x 5' down
into the centre of the hollow Gate post so that the hardware has something to bite