Instructions / Assembly

Installation Instructions Tub Tattoos
Installation Instructions
1. The first step is to decide how you want them to be laid out. The best way to get your
pattern right is to lay out all your treads or appliques on the tub without taking the
adhesive backing off. This way you can make sure you have full coverage.
2. Once you're satisfied with your layout, peal the backing off of the first applique.
3. Eliminate as many air bubbles as possible by pressing firmly starting in the middle and
working your way toward the edges. This will ensure consistent contact on the entire
surface.
4. Allow a minimum 4 hours of drying time before you use the shower. If possible, we
recommend that you give them a full 24 hours.
Easy and Effective Tread Installation
This applique installation guide applies to a variety of our products. If you are planning to
or have already purchased any of the following products, this guide is for you. If you have
purchased our recyclable bathtub treads, then these steps aren't required because they
use suction cups rather than adhesive.
Before you proceed with the installation below, ask yourself "Have I already properly
cleaned my tub?" If not then read our How to Clean and Prepare Your Tub guide.
Questions? www.SlipXSolutions.com or 1-800-968-0104

Summary of content (2 pages)