Installation Sheet

2
TOOLS REQUIRED FOR INSTALLATION
• 13 mm open end wrench or nut driver for faucet retainer nut
• 2.5 mm hex allen wrench
• 5/8” open end wrench for female end of flex hose
PRIOR TO INSTALLATION
Prior to installing the Sloan BASYS
™
Series Faucets, install the items listed
below. Also, refer to rough-in illustrations.
IMPORTANT:
• ALL PLUMBING SHOULD BE INSTALLED IN
ACCORDANCE WITH APPLICABLE CODES AND
REGULATIONS.
• FLUSH ALL WATER LINES PRIOR TO MAKING
CONNECTIONS.
• KEEP THREAD SEALANT OUT OF YOUR WATERWAY TO
PREVENT COMPONENT PART DAMAGE! DO NOT USE
ANY SEALANT ON COMPRESSION FITTINGS.
Base Plates
When the BASYS
™
Faucet is installed on a sink that has three (3) hole
punchings, a base plate should be used. Base Plates should be
specified at the time of ordering.
EFX-20-A – 4” (102 mm) Centerset Sinks
EFX-26-A – 8” (203 mm) Centerset Sinks
FAUCET ROUGH-IN
EFX-3X0.X0X.0100
with Hot/Cold Water Supply†
and 4-inch Base Plate
EFX-3X0.X0X.0000
with Tempered Water Supply†
EFX-6X0.X0X.0000
with Hot/Cold Water Supply†
SPOUT
1” (25 mm) MIN.
DIA. REQUIRED
3/8” (10 mm)
SUPPLY
TUBE
BATTERY
PACK*
MOUNTING
HARDWARE
SPOUT
BASE
PLATE
1” (25 mm) MIN.
DIA. REQUIRED
OPTIONAL
ADAPTER‡
MOUNTING
HARDWARE
3/8” (10 mm)
SUPPLY TUBES
3/8” (10 mm) COMPRESSION
STOPS (BY OTHERS)
3/8” (10 mm)
COMPRESSION
STOPS (BY OTHERS)
HOT
SUPPLY
COLD
SUPPLY
SPOUT
MOUNTING
HARDWARE
1” (25 mm) MIN.
DIA. REQUIRED
TEMPERED
SUPPLY
3/8” (10 mm)
SUPPLY
TUBE
BATTERY
PACK*
3/8” (10 mm)
COMPRESSION
STOPS (BY OTHERS)
TEMPERED
SUPPLY
† EFX Faucets are available with a 0.5 gpm (1.9 Lpm) multi-laminar spray,
1.5 gpm (5.7 Lpm) aerated stream, and 1.5 gpm (5.7 Lpm) laminar stream.
* One faucet per battery pack.
‡ No battery backup on hardwire low pedestal/low integrated base models.