Installation Sheet

ManualsBrandsSloan ManualsFlushometer ValvesSloan Battery-Powered, Sensor-Activated, Single-Flush Retrofit Conversion Kit for Exposed Closet Flushometers

SLEEVE ASSEMBLY

FLAT NOTCH

COLLAR NUT

GASKET

DO NOT REMOVE STICKER FROM SENSOR

WINDOW UNTIL STEP 2.

Close the control stop.

Using the supplied collar wrench, remove handle

and handle gasket from flushometer, if applicable.

NOTE: On some flushometers with

a faulty air vent, or recently flushed valve, be

prepared to collect a small amount of water with a

rag or sponge placed under the handle.

Place sleeve assembly with flat notch facing

upwards into collar nut and attach the Side Mount

unit where the handle was removed.

NOTE: Failure to install flat notch correctly can

result in damage to the unit.

Tighten collar nut with supplied collar wrench.

Open the control stop.

NOTE: Save the handle in the event you wish to

return to manual flushometer.

LIMITED WARRANTY

Unless otherwise noted, Sloan Valve Company warrants this product, manufactured and sold for commercial or industrial uses, to be free from defects in material

and workmanship for a period of three (3) years (one (1) year for special finishes, SF faucets, PWT electronics and 30 days for PWT software) from date of first

purchase. During this period, Sloan Valve Company will, at its option, repair, replace, or refund the purchase price of any product which fails to conform with this

warranty under normal use and service. This shall be the sole and exclusive remedy under this warranty. Products must be returned to Sloan Valve Company, at

customer’s cost. No claims will be allowed for labor, transportation or other costs. This warranty extends only to persons or organizations who purchase Sloan Valve

Company’s products directly from Sloan Valve Company for purpose of resale. This warranty does not cover the life of the batteries.

THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF. IN NO EVENT IS SLOAN VALVE COMPANY RESPONSIBLE FOR ANY CONSEQUENTIAL DAMAGES OF

ANY MEASURE WHATSOEVER.

1 - INSTALLATION (FOR EITHER LEFT- OR RIGHT-HAND)

Optima Plus

Dual-Flush and Single-Flush

Side Mount Unit Installation Instructions

Code No. 9108310

Rev.10 (01/16)

EBV-500-A

Single-Flush Side Mount

EBV-550-A

Dual-Flush Side Mount

Summary of content (4 pages)

PAGE 1
Code No. 9108310 Rev.
PAGE 2
1 - INSTALLATION (FOR EITHER LEFT- OR RIGHT-HAND) - CONTINUED NOTE: For retrofit installation to Sloan GEM•2 flushometer (-G variation). 1. Thread Chrome adapter onto valve body. 2. Place Yellow gasket on top of sleeve assembly. EBV-575 KIT 3. Mount side mount to valve body and tighten collar nut. NOTE: For retrofit installation to Zurn flushometer make sure to re-use the Zurn gasket and place on top of sleeve assembly before mounting to valve.
PAGE 3
SERVICE MODE - DUAL-FLUSH AND SINGLE FLUSH UNITS Press and hold the True Mechanical Override (BLACK) button for 10-20 seconds. The unit will exhibit an LED flash pattern as follows: • For approximately the first 10 seconds there will be no LED flashing. • For approximately 10-20 seconds, both the RED and GREEN LEDs will produce short simultaneous flashes. Release the TMO button during the 10-20 seconds when both the RED and GREEN LEDs produceWESHORT IV POT simultaneous flashes.
PAGE 4
PARTS LIST EBV-550-A DUAL-FLUSH SIDE MOUNT BATTERY COMPARTMENT HEX WRENCH 2.