Installation Sheet

ManualsBrandsSloan ManualsBathroom Sink FaucetsOptima Polished Chrome Touchless Single Hole Bathroom Sink Faucet

ADA Compliant

EAF-100/150 I.I. — Rev. 0a (11/02)

Code No. 0816542

INSTALLATION INSTRUCTIONS

ELECTRONIC, SENSOR OPERATED

LAVATORY FAUCETS

EEAAFF-115500 SSeerriieess

Battery Powered

Sensor Operated

Lavatory Faucets

EEAAFF-110000

SSeerriieess

Plug-in Transformer Powered

Sensor Operated

Lavatory Faucets

TThhee

nneeww

OOppttiimmaa ffaauucceett

——

BBrriinnggiinngg

iinntteelllliiggeennccee

ttoo

wwaatteerr

Sloan’s new Optima EAF-100/150 Series electronic hand

washing faucets operate by means of a dual infrared sensor and

microprocessor based logic. The modular design of the faucet

simplifies installation and maintenance by incorporating all of the

operating components above the sink within the die-cast metal

spout.

ISM models feature an integral temperature control lever to allow the

user to adjust water temperature. The faucet can also be adjusted to

a fixed setting. Faucets ordered without the ISM variation must be

connected to a single, pre-tempered water supply.

The faucet is also available with the

- Click

feature. This feature

allows the user to set faucet modes, including “continuous run” and

“temporary off” simply by pressing a button on the spout. This

feature is recommended only in installations where users have a

regular familiarity with the faucet (i.e., executive and non-public rest

rooms). Models furnished with the

- CClick

feature are also

available with a Drain Pop Up.

Optima EAF-150 series faucets include a 6 VDC lithium battery.

Battery life is approximately three (3) years. EAF-100 series faucets

are hard wired and include a plug-in transformer.

LIMITED WARRANTY

Sloan Valve Company warrants its Optima and Optima Plus EAF-100/150 Series Electronic Hand Washing Faucet to be made

of first class materials, free from defects of material or workmanship under normal use and to perform the service for which

it is intended in a thoroughly reliable and efficient manner when properly installed and serviced, for a period of three years

from date of purchase. During this period, Sloan Valve Company will, at its option, repair or replace any part or parts which

prove to be thus defective if returned to Sloan Valve Company, at customer’s cost, and this shall be the sole remedy

available under this warranty. No claims will be allowed for labor, transportation or other incidental costs. This warranty

extends only to persons or organizations who purchase Sloan Valve Company’s products directly from Sloan Valve Company

for purpose of resale. This warranty does not cover the life of the battery.

THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF. IN NO EVENT

IS SLOAN VALVE COMPANY RESPONSIBLE FOR ANY CONSEQUENTIAL DAMAGES OF ANY MEASURE

WHATSOEVER.

SLOAN VALVE COMPANY • 10500 Seymour Avenue • Franklin Park, IL 60131

Phone: 1-800-9-VALVE-9 or 1-847-671-4300 • Fax: 1-800-447-8329 or 1-847-671-4380

http://www.sloanvalve.com

Printed in the U.S.A. 11-02

PARTS LIST

Item No. Part No. Description

1A EAF-10 2.2 gpm (8.3 Lpm) Aerator Spray Head

1B EAF-12 0.5 gpm (1.9 Lpm) Spray Head

2A EAF-3-A Throat Plate Assembly (Battery Models)

2B EAF-6-A Throat Plate Assembly (Plug-in Transformer Models)

2C EAF-4-A Throat Plate Assembly with i.q. - Click (Battery Model)

2D EAF-7-A Throat Plate Assembly with i.q. - Click (Plug-in Transformer Model)

3 EAF-1000 Battery Replacement Kit

4 EAF-1 Faucet Mounting Kit

5 EAF-9 Strainer (Filter)

6A EAF-1001 Mixer Handle Assembly and Cartridge

6B EAF-1002 Handle Repair Kit

7 EAF-11 Transformer

8 EAF-5 Remote Control

9 ETF-607-A Trim Plate for 4” Center-set Sink

10 ETF-608-A Trim Plate for 8” Center-set Sink

Summary of content (6 pages)

PAGE 1
Part No. EAF-10 EAF-12 EAF-3-A EAF-6-A EAF-4-A EAF-7-A EAF-1000 EAF-1 EAF-9 EAF-1001 EAF-1002 EAF-11 EAF-5 ETF-607-A ETF-608-A 6B 3 7 4 9 10 8 SLOAN VALVE COMPANY • 10500 Seymour Avenue • Franklin Park, IL 60131 Phone: 1-800-9-VALVE-9 or 1-847-671-4300 • Fax: 1-800-447-8329 or 1-847-671-4380 http://www.sloanvalve.com Printed in the U.S.A. 11-02 Description 2.2 gpm (8.3 Lpm) Aerator Spray Head 0.5 gpm (1.
PAGE 2
ROUGH-IN — Figure 1 MODELS EAF-100/150-ISM MODELS EAF-100/150-ISM-DPU-IC 2.2 gpm (8.3 Lpm) Max. Flow Aerator Faucets with Hot and Cold Water Supply MODELS EAF-100/150 2.2 gpm (8.3 Lpm) Max. Flow Aerator Faucets with Single Line Water Supply SPOUT SPOUT MIXING VALVE 1-3/16” (30 mm) MIN. DIA. HOLE REQUIRED O-RING GASKET O-RING GASKET 1-1/2” (38 mm) MAX. DECK THICKNESS RETAINER 1-3/16” (30 mm) MIN. DIA. HOLE REQUIRED 1-1/2” (38 mm) MAX.
PAGE 3
FAUCET INSTALLATION Step 1 Step 4 Remove all Mounting Hardware: IMPORTANT: Flush dirt, debris, and sediment from Supply Line(s) before Connecting Flex Hoses. • Nut • Faucet Retainer • Gasket Do Not remove the O-ring from base of faucet. FLEX HOSE STRAINER Install Strainer and Flex Hose onto Supply Stop. O-RING — DO NOT REMOVE Tighten the Flex Hose (with Strainer in place) securely to the Supply. GASKET SUPPLY LINE/STOP FAUCET RETAINER NUT Step 5 Open Supply Stops.
PAGE 4
Step 8 OPERATION Activate Faucet and check for leaks. If range is unsatisfactory, refer to the section entitled “Range Adjustment” on this page. As the user’s hands enter the beam’s effective range, the beam is reflected back into the sensor receiver and activates the solenoid valve allowing water to flow from the faucet. Water will flow until the hands are removed or until the faucet reaches its automatic time out limit setting.
PAGE 5
-Click FEATURE EAF-5 REMOTE CONTROL The EAF-5 Remote Control may be used with all EAF faucet models. The Remote Control may be used to adjust or reset: • Sensor Range • Time Out Delay • Continuous Run/Temporary Off • Auto Set Range Adjustment The -Click feature is a button on the underside of the faucet spout that allows the user to place the faucet into the following function modes: Continuous Run, Temporary Off, Permanent Off and Auto Set Range Adjustment.
PAGE 6
BATTERY REPLACEMENT TROUBLESHOOTING GUIDE Replace the battery when the red LED indicator flashes each time the faucet is in use or when the faucet stops functioning. 1. Problem: Cause: Solution: Cause: Solution: Step 1 Close Supply Stop(s). Faucet does not function. Adhesive packaging label affixed over sensor eye Remove adhesive label from sensor eye "Permanent Off" activated Press button on faucet throat one time 2. Problem: Faucet delivers water in an uncontrolled manner.