Installation Sheet

Connect wiring
Connect the relay harness, which comes from the
bottom of the foam tank base case unit, with the
hand sensor harness, which comes from the
foam soap dispenser.
Protect wire connections
Feed the connectors of the relay harness and
hand sensor harness into the connector case as
shown in illustration. After positioning all wiring,
fold the connector case in half and close using
two stainless steel panhead screws.
• Be careful not to pinch the wiring in the
connector case.
Mount connector case
Completely clean the area where affixing the
connector case. Remove liner and affix one side
of the adhesive pad to the back of the connector
case.
Remove the adhesive liner on the pad affixed on
the connector case and attach to the underside or
back of basin or sink.
• When mounting the connector case, screws
must be accessable in case wiring needs
accessing.
• Harness openings must face down to keep
water from entering case.
Attach wire guide clips
• Attach wire guide clips to the bracket and
secure wires.
Plug in to electrical outlet
From foam soap
dispenser
Hand
sensor
harness
Relay
harness
From foam
tank case unit
Hand
sensor
harness
Connectors
Relay
harness
Connectors
Harness
openings
Connector case
Stainless
steel
panhead
screws
Adhesive
mounting pad
5
Wire guide
clips