Installation Sheet

Cleaning foam soap dispenser

If the tip of the soap nozzle is clogged, the

dispensing capability may fail or function partially.

Clean the nozzle according to the following

procedure:

• Press the operation switch to OFF (the

operation light goes off).

• Remove the nozzle using a 2.5 mm Hex key.

Next, remove the internal mesh. Wash it with

lukewarm water.

• Insert the mesh and then the nozzle back

into the spout and tighten with the hex key.

• Turn ON the operation switch (the operation

light goes on). Check the foam soap spraying

state.

• Repeat as needed.

Cleaning the hand sensor

Clean the hand sensor periodically (about once a

month) according to the following procedure:

• Press the operation switch to OFF (the

operation light goes off).

• Gently wipe the hand sensor area with a cloth

moistened with warm water.

• Press the operation switch to ON (the operation

light goes on).

• Make sure that the nozzles properly dispenses

foam soap.

NOTE: Do not leave water drops on the hand

sensor area. Remaining water drops may cause a

malfunction.

Mes

Nozzle

Before Calling for Repair

Problem Action

Unit does not operate. Check operation switch is on.

Check power plug is securely inserted to the outlet.

Soap does not dispense. Soap bottle needs replacing.

Check soap dispensing nozzle for clog.

Clean hand sensor.

Liquid soap is not in foam state. Check mesh is mounted in the

foam-dispensing nozzle.