Installation Sheet

Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help
10
TROUBLESHOOTING INSTRUCTIONS (CONT.)
Faucet delivers only a slow flow or dribble when sensor is activated.
A. Water supply valve is partially closed.
Open the supply stop(s) completely.
B. Inlet tting lter is clogged.
Remove, clean, and reinsert. Replace with EFP101A solenoid lter kit if necessary
C. Aerator or spray head is clogged.
Remove, clean, and reinsert.
Faucet DOES NOT stop delivering water or continues to drip after user is no longer detected (automatic shut-off fails even when bat-
teries are removed).
A. Solenoid valve seat is dirty.
Remove, clean, and reinsert solenoid lter. Activate faucet several times to ush out dirt.
B. Sensor range is set too long and is detecting the sink or some other object.
Reduce sensor detection range.
C. Solenoid valve module is not working properly.
Replace EFP103A solenoid valve module.
The water temperature is too hot or too cold on a faucet connected to hot and cold supply lines with
inlet filter fitting.
A. Supply stops are not adjusted properly.
Adjust supply stops.
NOTE: For some systems, a thermostatic mixing valve may be required
SLOAN • 10500 SEYMOUR AVENUE • FRANKLIN PARK, IL 60131
Phone: [phone] or 1-847-671-4300 • Fax: [phone] or 1-847-671-4380 • www.sloan.com
© 2020 SLOAN Code No: 0816843 – Rev. 2 (05/20)
If further assistance is required, please contact Sloan Tech Support
at 1-888-SLOAN-14 (1-888-756-2614)
DO NOT USE abrasive or chemical cleaners (including chlorine bleach) to clean faucet that may dull the luster and attack the chrome or special deco-
rative nishes. Use ONLY mild soap and water, then wipe dry with clean cloth or towel. While cleaning the bathroom tile, protect the faucet from any
splattering of cleaner. Acids and cleaning uids will discolor or remove chrome plating.
CARE AND CLEANING INSTRUCTIONS
This equipment has been tested and found to comply with the limits for a class B digital devices, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmfull interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmul
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
•
FCC INFORMATION TO USERS
•
•
•