User's Manual

uClinux NEEK BSP uClinux NEEK BSP Development Environment
3. Set the baud rate 115200, 8 bit, no parity and one stop bit. See the Figure 14
Figure 14 : Minicom Configuration Window3
4. You may set this configuration as default by selecting Save Setup as dfl
option after all configurations.
5. Now, download .sof and zImage from other terminal and you will see booting
on Minicom.
3.2 Running zImage on windows
3.2.1 Using JTAG UART Console
If you have selected JTAG UART as console while building the zImage then
follow the steps:
[SOPC Builder]$ nios2-configure-sof
sls_neek_bsp_hw.sof
[SOPC Builder]$ nios2-download -c USB-Blaster[USB-0]
zImage –g
[SOPC Builder]$ nios2-terminal
Here you can see Linux booting messages on same shell.
System Level Solutions 17