User Manual

05K
J A C K A R O O
ATT
RC A1/8” TR S
WAR NIN G: D O NOT ENGAG E CA BLE TES T WIT H
P OWER RU NNING T HRU THE TEST
CABLES!
RCA1/8” TR S XLR
XLR
Cable
Test
Test
Tone
1 2 3 4 5 6 7 8
MIDI
MIDI
RJ45
RJ45
RJ11
RJ11
1/4” TR S
1/4 ” TRS
Attenuator
Attenuator
05K
ATT
RC A1/8” TRS
RC A1/ 8” TRSXLR
XLR 1/4” TR S
1/4” TR S
2
Of f
5
5V d c
Off
12 V dc
9V ac
17V a c
Voltage selector
3
4
6
7
8
Monitor selector
Voltage out
Max 500mA
BNC
BNC
100hz 1k 10k
MONITOR SPEAKER
L-RATT PASS
TRGND LIFT
L-RATT PASS
TRLINK
Ba nan as:
48 V PH AN TO M PO WE R
SEND RECEI VE
Co ntin uity te ster
Wit h Beep er & LED
The JACKAROO lets you easily split signals, change connector gender,
perform attentuation, and more.
In this example we’ll take stereo 1/4" TRS cable and split the signal into two mono
RCA outputs.
1. Make sure that the CABLE TEST switch is NOT engaged
2. Connect the 1/4" TRS stereo source signal into the section A 1/4" input (lower left).
3. Connect an RCA cable to the section A RCA output (upper left) and a second
4. Select LEFT using the L-R switch in the section A control panel.
5. Select RIGHT and set LINK to ON in the section B control panel.
The signal will now be split.
If the signal level is too high on one or both sides, switch ATT (attenuation) ON and
use the rotary control(s) to attenuate the signal.
If the signal needs to be transformer isolated, or the ground needs to be lifted to
remove hum and noise, simply engage the GND LFT switch.
By following the above example, you can split, attenuate, and combine signals,
change the gender of connectors, and create a variety of input/output configurations.
SMPROAUDIO- JACKAROO
A B
0
0
5K
5K
ATT
ATT
Attenuator
Attenuator
L-R
L-R
ATT PASS
ATT PASS
TR
TR
GND LIFT LINK
A
B
JACKAROO-FUNCTIONS:-SPLITTING-signals
Splitting a stereo signal into dual mono signals
cable to the section B RCA output (upper right).