User and installation manual

5 Mounting
SMA Solar Technology AG
Installation Manual SBSxx-US-10-IA-xx-12 29
6. Hook the inverter into the wall mounting bracket.
Here, the lugs on the rear side of the Power Unit
must be hooked into the upper recesses and the lugs
in the Connection Unit into the lower recesses in the
wall mounting bracket.


7. Check whether the inverter is securely in place.
If the Connection Unit can be moved forward, the lugs on the rear side of the Connection Unit
are not hooked into the lower recesses in the wall mounting bracket. Remove the inverter from
the wall mounting bracket and hook it in again.
Once the Connection Unit cannot be moved forward, the inverter is securely in place.
8. Secure the inverter to the wall mounting bracket. To
do this, insert the screw M5x60 through the hole on
the left side of the PowerUnit using a Torx
screwdriver (TX25) and tighten it (TX25, torque: 1.7
Nm ± 0.3Nm (15.06in-lb ± 2.65in-lb)).
9. If the inverter is to be protected against theft, attach a padlock:
• To do this, guide the shackle of the padlock
through the provided hole on the left side of the
Power Unit and close the shackle.
• Keep the key of the padlock in a safe place.
ENGLISH