Installation Instructions

AES
GmbH
-
D
-
99310
-
Arnstadt
-
Markt 14
-
+49
-
3628
-
78300
-
www.ibri
-
aes.com
Multi Frequency Reader SA2
-
Integrated
RFID frequency 13.56 MHz 125 kHz
RFID protocol ISO 14443a all typical tags (extendable)
ISO 15693
Interface CAN
Operating voltage range 8...60 V
Max. operating voltage 72V
Max. power consumption 135 mW
CAN bus speed 1
25, 250, 500, 1000 kbit/s
Temperature range -
30...+70 °C
T
he reader supports the two main frequencies for RFID cards. At the
low frequency 125 kHz, a wide range of available transponders are
read. At the high frequency 13.56 MHz, the standards ISO14443a
and ISO15693 are implemented. NFC devices are detected. The
readable card range can be extended.
The reader implements the physical interface to the CAN bus.
The application areas of the rugged industrial reader can be used wherever transponder cards must be identified. Such
identification systems can launch vehicles, provide access free or allow other authorization or prohibit. The UID of
authorized cards are stored in the device. The release takes place by means of a command on the CAN-bus. The reader
can be trained with the help of a “TeachOn”-card. To store the UID’s at the “TeachOn”-card there exist a MTR-reader with
an USB HID connection to the PC. The user programs the UID's on the reader using a convenient PC program. When the
device is turned on the reader starts with the protocol of the “TeachOn”-card to configure the reader. The firmware can
be convenient updated via the CAN bus in the field.
The power supply comes maybe from vehicle batteries 12, 24 or 48V. Surges voltages as they occur during braking are
tolerated. For self-protection the device has internal suppressor diode triggers, when crossing the threshold voltage of
approximately 70V, a resettable fuse. The unit has reverse polarity protection against installation errors.
AES GmbH phone [phone] [e-mail]
Markt 14 www.ibri-aes.com
D-99310 Arnstadt
Germany