Installation manual

5
www.smartavi.com
Installation
Connecting XTAV transmitter
Connecting The Transmitter
1. Connect the output of the computer video card to the video input of the transmitter using the included male
to male video cable.
2. Connect the output of the computer audio card to the audio input of the transmitter using 3.5mm audio
male to male audio cable.
3. Connect external speakers to the transmitter’s audio out (Standard 3.5mm stereo miniplug).
4. In the back of the unit connect the CAT5 cable that will connect to the CATXPro.
Adjusting and Tuning the Signal (Skew)
In order to ne tune the signal, adjust the individual dials one at a time
starting with GREEN, then BLUE, and lastly RED. As you turn the dials you will
notice the colors slightly change as you increase or decrease the strength. All
dials should be approximately the same value.
Connecting the XTAV receiver
Connecting The Receiver
1. Connect CAT5 cable (coming from the CATXPro) to the back of the receiver.
2. Connect display monitors to the VGA out connector on the front of the receiver.
3. Connect external speakers to the audio output connections on the front of the unit. (Standard 3.5mm stereo
Miniplug)