User manual

Main Menu
To view the menu, press MENU. There are 6 menu options available:
Manage EDID - Gives the option to learn the EDID of your display or choose
a programmed EDID that is compatible with your monitor.
RS-232 Acknowledge - Sets the DVR16x16 to send a confirmation that an
RS-232 command has been received.
Send Update - Sets the DVR16X16 to send an RS-232 command back to
the controller when the configuration is changed via the front panel or re-
mote control (optional).
Memory Save - Sets the DVR16X16 to save the configuration when pow-
ered off.
Display Input Status - This displays the status of the inputs. If no input is
present, the display will read NONE. This is the default view.
Restore Factory Settings - Sets the DVR16x16 to the default factory con-
figuration.
USING RS-232 CONTROL (continued)
7. To reboot the processor:
//BOOT<CR>
8. To restore the matrix to factory defaults:
//RESET<CR>
You must cycle matrix’s power after this command.
9. To change data switching mode to RS-232 (user sets data
xpoints)
//RS<CR>
10. To change data switching mode to IR (data follows last switch to
any input)
//IR<CR>
11. To query version number:
//XXXX<CR>
B. Sending commands without CHECKSUM:
1. To set a video crosspoint:
\\FxxMyyIzz<CR>
Ex. to set video input 3 to output 12 on a router with the default frame
address “0” send the command: \\F00M12I03<CR>
2. To broadcast an input to all outputs:
\\FxxBzz<CR>
Ex. to broadcast input 3 to all outputs, send the command:
\\F00B04<CR>
3. To set RS-232 crosspoint:
\\FxxRyyIzz<CR>
4.To disconnect RS-232 crosspoint:
\\FxxDyyIzz<CR>
*A new method is to disconnect all: //F00D<CR>
5. To set new frame address:
\\FxxFnn<CR>
6. To query crosspoints from PC:
\\FxxU<CR>