Manual

SKM-04

CONNECTING THE SKM-04

1. Ensure that power is disconnected from SKM-04.

2. Use a USB cable (Type-A to Type-B) to connect a USB port on

a computer to the respective port of the SKM-04. Do this for

each of the computers.

3. Use 3.5mm Stereo (Male-to-Male) audio cables to connect

the audio out ports of the four computer to their respective

ports (Audio In ) of the SKM-04.

4. Optionally connect RS-232 for control functions.

5. Connect the USB keyboard and mouse on the two USB ports

on the right (close to the RS-232 port).

6. Connect speakers to the Audio Out port on the SKM-04

7. Optionally connect up to two USB 2.0 devices (flash drive,

printer, etc.) to the two USB ports on the left .

COMMANDS HOTKEYS RS-232 CONTROL

Single-head Display

Mode

ctrl + ctrl + k

k+ s

s //ks

ksks

Multi-head Display

Mode

ctrl + ctrl + k

k + m

m //km

kmkm

SKM-04 INITIAL SETUP

After connecting all devices to the SKM-04, a display topology

configuration and display mode must be chosen. By default,

SKM-04 is configured to single-head mode and a topology with

4 screens arranged horizontally starting with port 1 on the

most left-hand side.

1. The displays’ installation setup must match one of

SKM-04’s predefined display topology configuration. This

can be selected through keyboard hotkey commands or

through RS-232. Please refer to the “Display Topology Con-

figuration” for the available display topologies.

2. If one or more of the input computers have multiple

displays, Multi-head Display Mode must be selected.

Otherwise, select Single-head mode. Please refer to the

table below for the commands: