Installation Guide

10
3-wire receptacle
Turn off power supply to outlet.
Remove the screw securing the terminal block
access cover in the lower corner on the back of the
dryer.
power cord/strain relief manufacturer’s instructions in
the power cord entry hole below the access panel. At
this time, the strain relief should be loosely in place.
4 Thread an UNPLUGGED, UL-approved, 30 amp.
strain relief.
al on
the terminal block. Tighten the screw securely.
Attach the remaining two power cord outer
conductors to the outer, BRASS colored terminals on
the terminal block. Tighten both screws securely.
the strain relief and power cord.
Reinstall the terminal block cover.
ailure to
disconnect power source before servicing could result
Do not make a sharp bend or crimp wiring/conductor
at connections.
n a
3-wire system, move the internal ground from the
terminal block.
be
retrieved in the terminal screw recovery slot below the
access panel.
Internal ground
(GREEN screw)
Install
UL-approved
strain relief here
Terminal screw
recovery slot
Line 1
(BRASS terminal)
Neutral
(SILVER terminal)
Line 2
(BRASS terminal)
Access cover
screw
Terminal
block
Neutral
(center wire)
30 AMP
NEMA 10-30
DO NOT remove
internal ground in
a 3-wire system!!
Neutral
terminal