Installation Guide

Pg. 3
INSTALLATION INSTRUCTIONS
IMPORTANT
Do not overtighten.
...the refrigerator icemaker inlet has 1/4" plastic tube (Figure B).
Then use a 1/4" brass compression union enclosed:
A. Remove brass nut and sleeve from 90° water supply adapter.
B. Remove the compression nuts and sleeves from the brass
compression union.
C. Wrap Teflon tape around one side of the compression union
threads.
D. Insert the wrapped threads of the body of the compression
union into the 90° water supply adapter and tighten.
E. Remove nut and sleeve from other end of compression
union and discard.
F. Connect the end of the PEX connector to the other end of
the compression union and tighten.
G. Turn on water supply and check for leaks. If leaks occur,
tighten connection and recheck for leaks.
BRASS NUT
SLEEVE
90º ADAPTER
C
A. Remove nut and sleeve from one end of compression
union.
B. Take nut and sleeve from the compression union and place
the nut then the sleeve onto the refrigerator's plastic tubing.
C. Slide the brass insert provided with the refrigerator inside
the plastic tubing.
D. Place tubing squarely into body of compression union, slide
sleeve and nut into position on threads and tighten.
E. Remove nut and sleeve from other end of compression
union and discard.
F. Connect the end of the PEX connector to the other end of
compression union and tighten.
G. Turn on water supply and check for leaks. If leaks occur,
tighten connection and recheck for leaks.
Connect the other end of the PEX water line directly to the
ice maker inlet located on the back of the refrigerator
(Figure A) unless :
A. Take nut and sleeve from end of compression union and
place nut first, then sleeve, on tube from refrigerator.
B. Place tubing squarely into body of compression union,
slide sleeve and nut into position on threads and tighten.
C. Remove nut and sleeve from other end of compression
union and discard.
D. Connect the end of the PEX
connector to the other end
of compression union and tighten.
E. Turn on water supply and check for leaks. If leaks occur,
tighten connection and recheck for leaks.
B
..
.the refrigerator icemaker inlet has 90° Water Supply Adapter
(Figure C). Then use a 1/4" brass compression union enclosed:
WATER
SUPPLY VALVE
PEX WATER LINE
CONNECTOR
ICEMAKER INLET
...the refrigerator icemaker inlet has 1/4" copper tube (Figure B).
Then use the 1/4" brass compression union enclosed:
A