Installation Guide

Preinstallation Requirements
Tools and materials needed for installation:
Adjustable
Wrench
1. Shut off the cold water supply.
2. Connect either end of the stainless steel water line to the water supply
valve
.
3. Connect the other end of the stainless steel connector directly
to the ice
maker inlet located on the back of the refrigerator (See Page 3)
INSTALLATION INSTRUCTIONS
IMPORTANT
Do not overtighten.
Determine the Water Supply
Configuration
1. Shut Off Valve
2. PEX Supply Tubing
3. Copper Supply Tubing
(2) Installation Instructions for PEX Supply Line
1. Shut off the cold water supply.
2. Ensure that the PEX tubing has a clean cut at the connection point. Do not
re-use preexisting compression nuts or sleeves.
3. Take nut from end of compression union and place nut on PEX water
supply tube.
4.
5.
6.
Slide the supplied PEX compression sleeve onto the PEX water supply
tube. Do not use the brass compression sleeve with the PEX water line.
Place tubing squarely into body of compression union. Slide sleeve and nut
into position on threads and tighten. Remove nut and sleeve from other
end of compression union and discard.
Connect either end of the stainless steel water line to the other end of the
compression union.
7. Connect the other other end of the stainless steel water line directly to the
ice maker inlet located on the back of the refrigerator (See Page 3)
(3) Installation Instructions for Copper Supply Line
1. Shut off the cold water supply.
2.
3.
4.
Ensure that the copper tubing has a clean cut at the connection point. Do not
re-use preexisting compression nuts or sleeves.
Take nut and sleeve from end of compression union and place nut first, then
sleeve, on copper water supply tube.
Place tubing squarely into body of compression union, slide
sleeve and nut into
position on threads and tighten. Remove nut and sleeve from other end of
compression union and discard.
Connect either end of the stainless steel water line to the other end of the
compression union.
Connect the other end of the stainless steel connector directly to the ice maker
inlet located on the back of the refrigerator (See Page 3)
WATER
SUPPLY VALVE
Pg. 2
PEX
WATER SUPPLY
COPPER
WATER SUPPLY
PEX COMPRESSION SLEEVE
BRASS COMPRESSION SLEEVE
5.
6.
(1) Installation Instructions for Supply Shut Off Valve