Instruction Manual

Page 2/11
- FCC NOTICE -
SAFETY INFORMATION
This radio is restricted to occupational use, work related operations only where the radio
operator must have the knowledge to control its RF exposure conditions.
When the Push-to-Talk (PTT) button is pushed, the transceiver sends out radio frequency
(RF) signals. In August 1996, the Federal Communications Commission adopted RF
exposure guidelines with safety levels for hand-held wireless devices.
The device is authorized to operate at a duty factor not to exceed 50%.
WARNING
To maintain compliance with the FCC’s RF exposure guidelines, this transmitter and its
Antenna must maintain a separation distance of at least 1 inch (2.5 centimeters) from your
face and body.. Speak in a normal voice, with the antenna pointed up and away from the
face at the required separation distance.
NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a reasonable installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced electronics technician for help.