User's Manual

Appendix A Compliance Information

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Modifications not expressly approved by Device Manufacturer could void the user’s authority to

operate the equipment under FCC rules.

Part 15B Equipment

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications.

However, there is no guarantee that interference will not occur in a installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

 Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the manufacturer could void the user’s

authority to operate the equipment . Modifications not expressly approved by Device

Manufacturer could void the user’s authority to operate the equipment under FCC rules.

FCC RF Radiation Exposure and SAR Statements

The device has been tested for body-worn Specific Absorption Rate (SAR)compliance. The FCC has

established detailed SAR requirements and has established that these requirements. RF Exposure

Information The radio module has been evaluated under FCC Bulletin C95.1 and IEEE 1528 and found to

be compliant to RF Exposure from radio frequency devices.

This device meets the applicable government requirements for exposure to radio frequency waves. The

highest reported SAR level for usage near the body (0mm) is 0.94 W/kg.