Installation Instructions

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. Customer Service: 1-800-887-6326 (weekdays 9 a.m. – 5 p.m. CST)

3. READ AND SAVE THESE INSTRUCTIONS.

348-0032/ 348-0033

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Turn off the power at fuse or circuit box.

1. Unscrew four set screws to remove two end caps from fixture plate. (See Fig.2)

2. Attach the fixture plate to the location where you want to install, mark the target where is for two anchor to secure

fixture plate to the ceiling. Remove the fixture plate and drill two holes on the target. Hammer the anchors to target

holes tightly, and then secure the dry wall screws to anchors in part way. (See Fig.1)

3. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows:

---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.

---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.

---Connect the fixture grounding wire (usually green insulation or bare wire) to the house grounding wire from the power

source.

Carefully put the wires back into the outlet box. (See Fig.1)

Page 1 / 3

Important to Know

1. Read all instructions carefully before installation and operation.

2. If you are not familiar with state and local electrical codes, it is recommended that you consult with a qualified electrician.

3. Do not use in wet locations, use indoors only.

4. Non-replaceable LEDs.

5. Caution: LEDs emit bright light. Avoid looking directly into the light source for prolonged periods to avoid eye damage.

6. Not to be used with a dimming circuit or any other electronically controlled switch.

7. Specification:

Installation Steps

NO.

Dimension(inch)

Item #.

348-0033

48 5

348-0032

1.5

Watts

Hardware Package (Included):

Anchor (A)

Dry Wall Screw (B)

Wire Nut (C)

Plastic Plug (D)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS 348-0032/ 348-0033 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. Customer Service: 1-800-887-6326 (weekdays 9 a.m. – 5 p.m. CST) 3. READ AND SAVE THESE INSTRUCTIONS. Hardware Package (Included): Dry Wall Screw (B) Anchor (A) Wire Nut (C) Plastic Plug (D) Important to Know 1.
PAGE 2
Outlet Box Source Wire Wire Nut (C) Anchor (A) Fixture Wire Dry Wall Screw (B) PC Diffuser Set Screw Fixture Plate End Cap Fig.1 End Cap PC Diffuser Key hole slot Dry Wall Screw Fixture Plate Set Screw Fig.2 Fig.3 4. Attach the fixture plate to ceiling by inserting two dry wall screw heads into key hole slots, then slide the fixture plate to left or right until the heads of the dry wall screw are located into narrow ends of the key hole slot.
PAGE 3
Troubleshooting PROBLEM The fixture will not light The fuse blows or circuit breaker tips when the light is turn on. POSSIBLE CAUSE CORRECTIVE ACTION The power is off. Check to ensure the power supply is on The circuit breaker is off. Check to ensure the circuit breaker is in the on position There is a bad connection. Check to ensure proper wire connections are made. Contact a qualified electrician. There is a defective switch. Contact a qualified electrician.