Instructions / Assembly

ManualsBrandsSmart Garden ManualsKitchenCascadia Falls Electric Corner Fountain with LED's in Weathered Sienna Finish

Table Of Contents

Cascadia falls Instruction English.vsd
- Page-1
- Page 2

Cascadia falls corner fountain

1. Place the pump into the base reservoir next to the cable tube, feed the cable down

through the tubing and out underneath the base.

2. Connect the lower light unit.

3. Lower the upper tier onto the middle tier feeding the hose and upper light unit cable

through the cable tube.

4. Lower the upper assembled parts onto the base, connecting the hose to the pump and

the upper light unit.

5. Run the cable neatly from the base of the fountain and plug into the adaptor unit.

6. Ensure the connector is water tight by screwing the retaining collar into position.

7. Fill the main bowl with water to the desired level ensuring the pump is covered.

Note: Pump MUST never be used dry. Water must be regularly topped up. We recommend

regularly changing the water to ensure it remains clean and free from debris.

Assembly

Summary of content (4 pages)

PAGE 1
Cascadia falls corner fountain Assembly 3 1 6 2 1. 2. 3. 4. 5. 6. 7. Place the pump into the base reservoir next to the cable tube, feed the cable down through the tubing and out underneath the base. Connect the lower light unit. Lower the upper tier onto the middle tier feeding the hose and upper light unit cable through the cable tube. Lower the upper assembled parts onto the base, connecting the hose to the pump and the upper light unit.
PAGE 2
Connection & Operation You are now ready to connect your fountain to the power source. The plug from the adaptor can be connected to any suitable indoor or outdoor GFCI protected socket. If connecting outdoors you must also ensure you connect the plug within a suitable weather proof enclosure. The adaptor itself is suitable for outdoor use but the connection to the power source must be within a weatherproof area.
PAGE 3
Rev.A OCEAN KEY INSTRUCTIONS OK130LV12V60 PUMP Ocean Key pumps are carefully inspected and tested to ensure both safety and operating performance for pond and fountain applications. However, failure to follow the instructions and warnings in this manual may result in pump damage and/or serious injury. Be sure to read and save this manual for future reference.
PAGE 4
-MAINTENANCEA clogged or dirty intake screen will greatly reduce performance. If the pump is used on a dirty surface, raise it slightly to reduce the amount of debris contacting the intake. If less flow is desired, adjust it with the flow control. Never restrict the pump’s intake. To clean the pump, remove the front plate and the impeller. Use a small brush or stream of water to remove any debris. CAUTION: The pump shaft cannot be removed.