Use and Care Manual

2 7

Fill bowl with water.

Attach metal ring

to frame.

Place Bowl.

Insert Solar panel/pump.

Affix bolts and

wingnuts, and

attach bowl.

Open frame.

Pump Removal / Assembly

Remove the top tier and turn upside down on a soft

surface. As you turn, ensure the solar panel is

supported so that it does not fall out. Remove the

pump from the connecting tubes and disconnect

the cable.

Connect the pump to the

underside of the solar panel as

shown and check to ensure the

connectors are water tight. When

reconnecting slightly twist when

pushing together, ensure the red

sealing ring remains in it’s groove

and is not displaced.

Ensure both tubes (1) are connected so the pump will

remain fully submerged. Slide the rubber bung (2) onto

the tube and move it down until it is half way down the

top tube. Insert the top tube (1) into the bottom of the

solar panel (3) by squeezing the pump and panel

together. Push the rubber bung (2) into the reservoir

hole so it creates a seal. If done correctly, the panel will

not lift out.

To ensure the tubes from the pump are connected to

the solar panel, try lifting the solar panel gently by

pulling on the solar panel nozzle (4). If the panel lifts

out the tubes are not connected. See illustration below

for assembly.

Important

2-Tier Fountain

Birdbath

Place Bowl.

Insert Solar panel/pump.

Fountain Heads