Instructions / Assembly

ManualsBrandsSmart Solar ManualsAccessoriesAquaNura Solar Birdbath Fountain Conversion Kit

AquaNura Solar Birdbath Kit

0°C /32°F





Configuration and Assembly

In strong sunlight or windy conditions, the water may spray outside of the birdbath.

We recommend the water be regularly topped off and changed to ensure it remains

clean and free from debris. Shallow birdbaths require more frequent filling due to

evaporation or the pump will run dry, which may cause damage

Frost causes damage and is not covered by warranty. Empty water and store product

inside during cold weather. For safety, we recommend doing this when the weather is

going to dip below 40°F.

Unit includes:

Solar panel housing x1

Support ring (attached) x1

Pump x1

Fountain head set x1

1” Extension tube x1

The AquaNura can be configured to allow use with a variety of birdbaths.

Below are some suggestions. You may need to adjust the components based

upon your birdbath. You must have a minimum of 1.5” of water to work correctly.

Deep Birdbath

(2+ inches) with Flat Bowl

Shallow Birdbath

with Flat Bowl

Shallow Birdbath with

Curved Bowl

• Use with support ring attached

• Connect pump tube directly into

bottom of solar panel

• Solar panel will not be effected

if submerged underwater

• Remove support ring

• Connect pump tube directly

into bottom of solar panel

• Remove the support ring

• Add 1” tube between the

underside of solar panel and

pump. This will lower the pump

closer to bottom of bowl.

See next page for instructions on how to attach pump and remove support ring.

* Birdbath not included

Warning! Important! Read Me!

1” Extension tube

Pump

1” Extension tube

Fountain head set

Summary of content (4 pages)

PAGE 1
AquaNura Solar Birdbath Kit Configuration and Assembly Unit includes: Solar panel housing x1 Support ring (attached) x1 Pump x1 Fountain head set x1 1” Extension tube x1 * Birdbath not included Fountain head set 1” Extension tube The AquaNura can be configured to allow use with a variety of birdbaths. Below are some suggestions. You may need to adjust the components based upon your birdbath. You must have a minimum of 1.5” of water to work correctly.
PAGE 2
BEFORE USE: Connect the tube on the pump to the hole in the underside of the solar panel. Connect the cables, ensure the connections are water tight. ! Important    Circuit box In order to remove the support ring, turn the solar panel housing upside down. Hold the circuit box with one hand, and with your other hand turn the support ring to the right to unlock. OR Fill your birdbath with water and place the AquaNura into the birdbath. Attach the fountain head of your choice. 2 .
PAGE 3
Position   Position your AquaNura so that receives direct sunlight. The fountain will NOT work if the solar panel is in a shaded area. Performance This product is designed primarily to operate in summer months but will also work in spring and autumn provided there is strong direct sunlight. Performance is directly related to the amount and strength of sunlight received. The 360˚ fountain head will work effectively in strong direct sunlight.
PAGE 4
Maintenance L To maintain optimum performance, regularly clean the solar panel using water or glass cleaner with a non-abrasive sponge or cloth. If the fountain head, nozzle, or tubes become blocked, rinse through with water. Troubleshooting Tips • Ensure the cables from the pump to the solar panel are connected properly. • Ensure the pump tube is connected to the underside of the solar panel. • Check water level in birdbath to ensure pump is fully submerged.