Instructions / Assembly

Aquarius birdbath with glass orb

Introduction

Solar Lights work by using electricity generated by the solar panel to charge internal batteries.

These batteries are then used to power the light. When switched on the lights automatically

illuminate at night by using a light sensor. The duration of illumination will depend on the

amount of sunlight and therefore charge received by the batteries.

Assembly

Position

1. Screw the fork section to the middle section.

2. Align and lower the birdbath into position until it reaches the stop.

3. Tighten the retaining screw that holds the birdbath in place.

4. Screw the top section with bird and orb to the middle section.

Position the light to receive the

maximum amount of sunlight.

Do not position where the solar

panel will be shaded.

PAGE 1
Aquarius birdbath with glass orb Introduction Solar Lights work by using electricity generated by the solar panel to charge internal batteries. These batteries are then used to power the light. When switched on the lights automatically illuminate at night by using a light sensor. The duration of illumination will depend on the amount of sunlight and therefore charge received by the batteries. Assembly 2 4 3 1 1. 2. 3. 4. Screw the fork section to the middle section.
PAGE 2
û Do not position under bright light as this will prevent the light switching on at night. First Use Switch Although there may be some initial charge in the battery we recommend fully charging it before first use. Leave the switch in the off position for 1 sunny day to ensure the battery is fully charged. Once fully charged switch to “Auto” and the light will automatically illuminate when it gets dark. You can cover the solar panel to test that the light is operating.