User's Manual

11
- The transmitter and the magnet must be no more than 0.5mm apart.
C. Mounting with the Double-Sided Adhesive
- Ensure the mounting surface is clean.
- Peel back one layer of the protective film and attach it to the transmitter.
- Peel back the remaining layer of protective film and press the transmitter firmly in place against the mounting
surface until firmly attached.
- Repeat to attach the magnet.
4.2.2 Installing the Motion Sensor WS103
The Wire-Free Home Protection System WS100S includes one Motion Sensor set described as a passive
infrared sensor (PIR). PIR sensors are designed to sense movement of anyone or anything that exceeds 36 kg
(80 lbs) in a given area. If less than 36 kg (80 lbs), not alert message is transmitted. Note: Pets larger than 36 kg
(80 lbs) must be no more than 1 meter high. It is best if pets are not allowed onto higher surfaces so that the s
sensors are not triggered unnecessarily. Also, the sensors become increasingly sensitive the closer the movement.
A. Powering up the Motion Sensor WS103
Remove the battery cover; insert a 9V battery noting the polarity as shown in diagram below; replace cover.
(Requires 1 - 9V battery, Not Included)
B. Installing the Motion Sensor WS103
- First, determine the location of the Motion Sensor.
Note:
- The Sensor should not be easily accessible.
- The Sensor should be placed in the most vulnerable rooms or near key entry points.
- Place the Sensor on a sturdy surface between 1.8m to 2.4mm (6ft to 8ft) from the floor.
- The Sensor should not be placed near extreme temperature sources (ovens, stoves etc.
- The Sensor should not be placed in direct sunlight.
- Do not install the Sensor outdoors or behind partitions.
You have the choice of attaching the Motion Sensor with screws or the adhesive provided.
C. Mounting using the Double-Sided Adhesive
- Ensure the mounting surface is clean.
- Peel back on layer of the protective film and attach it to the back of the Motion Sensor.
- Peel back the remaining layer of protective film and press the Motion Sensor firmly in place against the
mounting surface until firmly attached.
D. Mounting using Screws
- Hold the enclosed mounting template against the wall at the selected location and mark the points for drilling.
- Drill the holes and insert wall plugs.
- Attach the bracket to the mounting surface with the screws provided.
- Attach the Motion Sensor to the mounting bracket.
WS103