User's Manual

7
Sound: Alarm Siren (3minutes)
*To turn off the siren, enter the 4-Digit PIN or press on the remote
control to exit the current mode.
D. Triggers in ARM Mode
Press
to Complete the setting
After the setting is completed, return the Smart Panel to STANDBY for
mode selection.
LCD will shown per below:
Step Keys Description Note
2
1
3
4
Enter 4-DIGIT PIN
for setting
“ARM” Mode
Press then to
set the ARM mode
Step Keys Description Note
- Toggle 1, 2, 3, 4, 5, 6, 7, 8 to turn each zone ON or OFF
- If no number appears, the zone is turned OFF
- The LCD screen will display the below image:
4-DIGIT
PIN
(One beep indicates that you entered a valid PIN; Three beeps indicate
that an invalid operation was performed).
Example: Zone 1 trigger
Smart Panel’s alarm will sound and a Red LED and will flash
when the system is triggered.
2 System trigger
3 Entry delay 30 seconds
One beep indicates that the system is triggered.
There are 30secs. of entry delay time with visual count down for
disarming
Smart Panel’s alarm will sound and RED LED flashes when system
triggered without disarming in 30secs.
4
The System sounds for
3 minutes
The Smart Panel Red LED & will flash until the system is disarmed.
5
Return to ARM Mode
after the 3 minute siren
3.3.3 ALERT Mode
If in Alert mode, the Smart Panel chime will sound and a Green LED will flash when the system detects a visitor in the
protected area.
A. Entering ALERT Mode
- First make sure the Smart Panel is in STANDBY Mode
- On the Smart Panel: Enter your 4-Digit PIN + “ENTER” then press to activate.
- On the Remote Control: Press to activate.