User's Manual

8
ZONE1 ZONE2 ZONE3 ZONE4 ZONE5 ZONE6 ZONE7 ZONE8
ALERT
Mode
ALERT Disabled ALERT ALERT ALERT ALERT ALERT ALER
T
B. Triggers in ALERT Mode
- Example: Zone setting:
Programming a Zone in each mode:
3.3.4 HOME Mode
There are default settings that allow the system to operate after opening the package. You can adjust the settings to
suit your needs. This mode allows the system operate in both the Arm and Alert Modes in different zones.
“Standby” Mode1
2
3
4
You must be in STANDBY mode
*To make sure you are in STANDBY mode:
- Enter default PIN 1 2 3 4 OR your new 4-Digit PIN
- Press ENTER
- The LCD screen will display the below image:
(One beep indicates that you entered a valid PIN;
Three beeps indicate that an invalid operation was
performed).
The LCD screen will display the below image:
Enter 4-DIGIT PIN for
setting
(One beep indicates that you entered a valid PIN;
Three beeps indicate that an invalid operation was
performed).
Toggle 1, 2, 3, 4, 5, 6, 7, 8 to turn each zone ON or OFF
- If no number appears, the zone is turned OFF
- The LCD screen will display the below image:
After setting is completed, the Smart Panel will
return to STANDBY Mode, ready for mode
selection.
(1234 /
4-DIGIT PIN)
+
4-DIGIT PIN
Press to
complete the setting
Press then to
set the ALERT Mode
Keys Description NoteStep