User's Manual
SECTION 6 – GENERAL INFORMATION
5.2 Troubleshooting
AC power failure:
This may occur if your security system is accidentally unplugged or if there has been a main power cut. If a full
power failure occurs, please contact your electric company to find out the source of the problem. The back-up
battery will continue to run the system for approximately 6 hours.
System battery failure:
This may occur if the emergency back-up battery has been drained and needs to be replaced. If AC power is
not restored, the low battery symbol will flash indicating that the Smart Panel back-up battery is running low.
The back-up battery should be replaced once the low battery symbol appears.
Sensor failure:
This may occur if a sensor is not communicating with the Smart Panel. It is necessary for you to ensure the
House Security Code dipswitch and jumpers of the sensors are set correctly to the Smart Panel.
6.1 Product Information
Wireless systems are reliable and tested to high standards; however, it is important to consider that there are
some limitations due to their transmitting power and range:
code selected.
- A receiver can only respond to one transmitted signal at a time.
to protect against faults.
6.2 Specifications
6.2.1 Smart Panel
Power source: AC adaptor
Back up power: 9V ( 6LR61 ) alkaline battery x1pc
Sensor numbers: Unlimited
House Code: 4 Jumpers
Siren output: 120dB (Duration-adjustable)
6.2.2 Key Fob Remote Control
Power source: 12V ( MN27 ) alkaline battery x 1pc
House Code: 4 Jumpers
Wireless range to Smart Panel: <65 meters (open area)
6.2.3 Door/Window Sensor
Power source: AAA ( LR03 ) alkaline battery 1.5V x 2pcs
House Code: 4 Jumpers
Zone Code: Pin header: 8 pin
Wireless range to Smart Panel: <150 metres (open area)
6.2.4 Motion Sensor
Power source: 9V ( 6LR61 ) alkaline battery x1pc
PIR detection angle: <110 Degree (@9VDC)
PIR detection range: “H”:< 15M “M”:< 6M “L”:< 4M
House Code: 4 Jumpers
Zone Code: Pin header: 8 pin
Wireless range to Smart Panel: <150 meters (open area)
Power saving timer: 3 minutes
6.3 Maintenance
The product may be cleaned with a soft damp cloth and then wiped dry. Do not use abrasive, solvent based
or aerosol cleaners as this may damage and/or discolor the product. Do not allow water to enter or attempt to
clean the inside of the unit.
6.4 Batteries
Do not allow batteries to corrode and leak as this may cause permanent damage to the product.
Take care to insert the batteries with the correct polarity as shown inside the battery compartments.
Do not mix new and old batteries or different types of batteries.
Do not fit rechargeable batteries.
At the end of their useful life the batteries should be disposed of via a suitable Recycling Centre. Do not
dispose of with your normal household waste. DO NOT BURN
.
- 21 -- 20 -