User's Manual
Table Of Contents
- Cover
- Important information
- Contents
- Chapter 1: Welcome
- Chapter 2: Installing the display
- Chapter 3: Connecting power and devices
- Chapter 4: Configuring the display
- Chapter 5: Configuring connected computers
- Chapter 6: Maintaining the display
- Chapter 7: Troubleshooting
- Troubleshooting the display
- Troubleshooting the display’s software
- Referring to the SMART knowledge base for additional troubleshooting information
- Contacting your reseller for additional support
- Appendix A: Using settings
- Appendix B: Remotely managing the display
- Appendix C: Hardware environmental compliance
CHAPTER 1
WELCOME
7 smarttech.com/kb/171164
No. Name Procedure
1 Power
l
Press to enter or exit Standby mode.
l
Press and hold for four seconds to turn off the display.
l
Press and hold for 10 seconds to reset the display.
2 Volume increase Press to increase the volume.
3 Volume decrease Press to decrease the volume.
4
Freeze
Press to freeze and unfreeze the screen.
5 USB Type A
connector (×2)
Connect USB drives and other devices that you want to use
with the iQ appliance or a connected computer.
6 HDMI 2 input
connectors
Connect a computer or other input source to use with the
display (see page21).
NOTE
The Power button indicates the display’s status:
Power button Display status
Off Not receiving power
Amber Standby mode
White Normal operating mode
Presence detection sensors
The display has two presence detection
sensors on its top frame that can detect
people up to 16' (5 m) away when the
display is in Standby mode.
When the sensors detect people in the
room, the display is ready to turn on. To
turn on the display, press the Power
button
or pick up a pen or eraser.
If the room is empty for a specified
period, the display returns to Standby
mode.