User's Manual
Table Of Contents
- Cover
- Important information
- Contents
- Chapter 1: Welcome
- Chapter 2: Installing the display
- Chapter 3: Connecting power and devices
- Chapter 4: Configuring the display
- Chapter 5: Configuring connected computers
- Chapter 6: Maintaining the display
- Chapter 7: Troubleshooting
- Troubleshooting the display
- Troubleshooting the display’s software
- Referring to the SMART knowledge base for additional troubleshooting information
- Contacting your reseller for additional support
- Appendix A: Using settings
- Appendix B: Remotely managing the display
- Appendix C: Hardware environmental compliance
CHAPTER 2
INSTALLING THE DISPLAY
18 smarttech.com/kb/171164
NOTE
For more information on using RS-232 cables for remote management, see Appendix B:
Remotely managing the display on page73.
Installing the display on a stand
If you want to move the display from place to place or if it’s not possible to install the display on a
wall, you can install it on a stand.
IMPORTANT
If you install the display on a stand, do not move the stand while the display is on.
For information on selecting and using a third-party stand, see SMART installation standards
(smarttech.com/kb/171035).