User's Manual
Table Of Contents
- Cover
- Important information
- Contents
- Chapter 1: Welcome
- Chapter 2: Installing the display
- Chapter 3: Connecting power and devices
- Chapter 4: Configuring the display
- Chapter 5: Configuring connected computers
- Chapter 6: Maintaining the display
- Chapter 7: Troubleshooting
- Troubleshooting the display
- Troubleshooting the display’s software
- Referring to the SMART knowledge base for additional troubleshooting information
- Contacting your reseller for additional support
- Appendix A: Using settings
- Appendix B: Remotely managing the display
- Appendix C: Hardware environmental compliance
Chapter 3
19 smarttech.com/kb/171164
Chapter 3: Connecting power and devices
Connecting power 20
Connecting to a network 20
Connecting cables for room computers, guestlaptops and other input sources 21
Using recommend cables 22
Connecting to the connector panel 22
Connecting to the convenience panel 23
Viewing a connected computer or other device’s input 23
Connecting external speakers 23
Connecting other devices 24
Connector reference 25
Display connectorpanel 25
Display convenience panel 26
iQ appliance 26
Other connectors 27
Connect the display to power after you install it but before you turn it on for the first time and
configure the iQ appliance. You can also connect cables for room computers, guest laptops or
other input sources as well as for speakers and other devices.
By installing cables in advance, you make use of connectors that might not be accessible after the
display is wall-mounted. You can then run the cables across floors or behind walls as needed.
WARNING
Ensure that any cables that cross the floor to the display are properly bundled and marked to
avoid a trip hazard.