User's Manual
Table Of Contents
- Cover
- Important information
- Contents
- Chapter 1: Welcome
- Chapter 2: Installing the display
- Chapter 3: Connecting power and devices
- Chapter 4: Configuring the display
- Chapter 5: Configuring connected computers
- Chapter 6: Maintaining the display
- Chapter 7: Troubleshooting
- Troubleshooting the display
- Troubleshooting the display’s software
- Referring to the SMART knowledge base for additional troubleshooting information
- Contacting your reseller for additional support
- Appendix A: Using settings
- Appendix B: Remotely managing the display
- Appendix C: Hardware environmental compliance
CHAPTER 3
CONNECTING POWER AND DEVICES
20 smarttech.com/kb/171164
Connecting power
Connect the supplied power cable from the AC power inlet on the
bottom of the display to a power outlet.
NOTE
Refer to the display’s specifications for power requirements and power consumption information
(see More information on page9).
Connecting to a network
The display requires a network connection for downloading software
and firmware updates, and a number of the iQ appliance’s apps require
a network connection as well. You can connect to a network using a
Wi-Fi connection or one of the RJ45 jacks on the display (pictured). For
more information about the display’s network connection and
configuration, see Connecting to a network on page30.
IMPORTANT
Do not use the RJ45 jack on the iQ appliance to connect to a network.