User's Manual
Table Of Contents
- Cover
- Important information
- Contents
- Chapter 1: Welcome
- Chapter 2: Installing the display
- Chapter 3: Connecting power and devices
- Chapter 4: Configuring the display
- Chapter 5: Configuring connected computers
- Chapter 6: Maintaining the display
- Chapter 7: Troubleshooting
- Troubleshooting the display
- Troubleshooting the display’s software
- Referring to the SMART knowledge base for additional troubleshooting information
- Contacting your reseller for additional support
- Appendix A: Using settings
- Appendix B: Remotely managing the display
- Appendix C: Hardware environmental compliance
CHAPTER 3
CONNECTING POWER AND DEVICES
21 smarttech.com/kb/171164
TIP
If you’re using one of the display’s RJ45 jacks to connect to a network,
you can connect the other RJ45 jack to a computer to provide
network access for the computer. This is particularly useful if there is
only one wired network connection in the room.
Connecting cables for room computers,
guestlaptops and other input sources
You can connect cables to the display so that users can connect and use room computers, guest
laptops or other devices, such as Blu-ray™ disc players.
IMPORTANT
Do not connect computers or other devices to the iQ appliance. SMARTBoard 7000 series
interactive displays do not support the use of this connector.
NOTE
For information about configuring connected computers, see Chapter 5: Configuring connected
computers on page39.