User's Manual
Table Of Contents
- Cover
- Important information
- Contents
- Chapter 1: Welcome
- Chapter 2: Installing the display
- Chapter 3: Connecting power and devices
- Chapter 4: Configuring the display
- Chapter 5: Configuring connected computers
- Chapter 6: Maintaining the display
- Chapter 7: Troubleshooting
- Troubleshooting the display
- Troubleshooting the display’s software
- Referring to the SMART knowledge base for additional troubleshooting information
- Contacting your reseller for additional support
- Appendix A: Using settings
- Appendix B: Remotely managing the display
- Appendix C: Hardware environmental compliance
CHAPTER 6
MAINTAINING THE DISPLAY
43 smarttech.com/kb/171164
To evaporate condensation from the display
1. Remove the humidity source from the display, if possible.
2. Turn off the display.
3. Remove any moisture from the display with a smooth, dry cloth.
4. If the display has been moved from a colder environment to a warmer environment (for
example, from storage to the installation site), leave the display turned on for 48 hours.
Otherwise, leave the display turned off for 48 hours.
Replacing the pens and eraser
To prevent damage to the display’s anti-glare coating, replace a pen if its nib or eraser pad
become worn. You can purchase replacement pens and erasers from the Store for SMART Parts
(seesmarttech.com/Support/PartsStore).
Turning the display off and back on
In some situations, you need to turn off the display for a period of time. You can turn it back on
after.
To turn the display off
1.
Press the Power button
on the convenience panel for four seconds.
A slider appears on the screen.
2. Move the slider to the right.
3. Flick the switch beside the AC power inlet to the OFF(O) position.
NOTE
Wait at least 30 seconds before turning the display back on.
To turn the display back on
Flick the switch beside the AC power inlet to the ON(I) position.