User's Manual

APPENDIX B
REMOTELY MANAGING THE DISPLAY
77 smarttech.com/kb/171164
If you type a command that the room control system doesn’t recognize, you will receive an invalid
command response.
In the example below, the user included an extra space in the volume command.
INCORRECT
>set vol ume=65
invalid cmd=set vol ume=65
NOTES
l Use ASCII formatted commands.
l Commands aren’t case-sensitive.
l Review each entry carefully before you press ENTER.
l Don’t send another command until you receive the response and the next command
prompt.
To identify the current value of a setting
Use a get command.
This example shows how to get the volume:
>get volume
volume=55
To assign a value to a setting
Use a set command.
This example sets the volume to 65:
>set volume=65
volume=65