User's Manual

APPENDIX B
REMOTELY MANAGING THE DISPLAY
78 smarttech.com/kb/171164
To increase or decrease the value of a setting
Use the set command to increase or decrease the value by a designated number.
This example increases the volume by 5:
>set volume+5
volume=70
This example decreases the volume by 15:
>set volume-15
volume=55
To identify or assign a value for a specific display
Start the command with [Display],@, where [Display] is the display you want to apply the
command to.
This example sets the input for the rightmost display to HDMI 2:
>A,@ set input=hdmi2
@,A input=hdmi2
NOTES
o
The rightmost display is labeled A, the next rightmost display is labeled B, and so on.
o
You can identify a specific display for only the getinput, setinput and getfwver
commands.