User's Manual
Table Of Contents
- Cover
- Important information
- Contents
- Chapter 1: Welcome
- Chapter 2: Installing the display
- Chapter 3: Connecting power and devices
- Chapter 4: Configuring the display
- Chapter 5: Configuring connected computers
- Chapter 6: Maintaining the display
- Chapter 7: Troubleshooting
- Troubleshooting the display
- Troubleshooting the display’s software
- Referring to the SMART knowledge base for additional troubleshooting information
- Contacting your reseller for additional support
- Appendix A: Using settings
- Appendix B: Remotely managing the display
- Appendix C: Hardware environmental compliance
APPENDIX B
REMOTELY MANAGING THE DISPLAY
80 smarttech.com/kb/171164
No. of
displays
Get command Set command Response
Brightness
[N/A] get brightness set brightness[Value]
Where [Value] is one of the
following:
l
+[Value]
l
-[Value]
l
=[5–100]
brightness=[Value]
Where [Value] is a number
between 5 and 100
Freeze
[N/A] get videofreeze set videofreeze[Value]
Where [Value] is one of the
following:
l
=on
l
=off
videofreeze=[Value]
Where [Value] is one of the
following:
l
on
l
off
Volume
[N/A] get volume set volume[Value]
Where [Value] is one of the
following:
l
+[Value]
l
-[Value]
l
=[0–100]
volume=[Value]
Where [Value] is a number
between 0 and 100
Mute
[N/A] get mute set mute[Value]
Where [Value] is one of the
following:
l
=on
l
=off
mute=[Value]
Where [Value] is one of the
following:
l
on
l
off
Firmware version
One get fwver [N/A] fwver=[Value]
Where [Value] is the firmware
version.
More than
one
[Display],@ get fwver
Where [Display] is the
display’s label (A, B, and so on).
[N/A] @,[Display] fwver=[Value]
Where
l [Display] is the display’s
label (A, B, and so on).
l [Value] is the firmware
version.
Serial number
[N/A] get serialnum [N/A] serialnum=[Value]
Where [Value] is the serial
numbers of connected displays.