Graphics Tablet User Manual

10 Installing the DT770
3. Place the pen in the recess below the interactive screen so that it’s available for use. The
recess holds the pen magnetically.
Reattaching the Connection Panel’s Protective Cover
If you wish, after you have connected all of the DT770’s cables, you can reattach the protective
cover.
1. Feed the cables through the semi cylindrical channel in the back of the DT770 so that when
you reattach the protective cover, it will not trap any of the cables. Then place the cover over
the connection panel.
2. Tighten the captive screws using the supplied screwdriver.
To reattach the protective cover
Pen Recess
Semi-cylindrical
channel
NOTE: For clarity, the
DT770 is shown
without the cables
NOTE: If you like, you can
feed the pen’s tether through
the gap at the bottom of the
cover, instead of through the
semi-cylindrical channel.