User Manual

i smarttech.com/kb/170769
Important information
WARNING
l The capture board includes instructions for installation on metal and wood stud walls and
certain masonry wall types only. A SMART hardware kit is available for these types of
installation. In the event that you need to install the capture board on reinforced concrete
walls, walls with plaster lath finishing or other types of walls, refer to your local building
authority for instructions, recommendations and safe work practices.
l Do not open or disassemble the capture board. You risk electrical shock from the high
voltage inside the casing. Opening the casing also voids the warranty.
l Ensure that any cables that cross the floor to the capture board are properly bundled and
marked to avoid a trip hazard.
l Ensure your installation complies with local building and electrical codes.
l Failure to follow the installation instructions shipped with the capture board could result in
injury and product damage which may not be covered by the warranty.
l To reduce the risk of fire or electric shock, do not expose the capture board to rain or
moisture.
l Use SMART supplied mounting hardware or hardware that is designed to properly support
the weight of the capture board.
l Use the power cable provided with the capture board. If a power cable is not supplied with
the capture board, please contact your supplier. Use only power cables that match the AC
voltage of the power outlet and that comply with your country’s safety standards.
l Do not place any heavy objects on the power cable. Damage to the cable could cause
shock, fire or product damage which may not be covered by the warranty.
Federal Communication Commission
interference statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.