User Manual

CHAPTER 4
MAINTAINING THE CAPTURE BOARD
29 smarttech.com/kb/170769
To clean the reflective bezels and corner sensors—Method 2
1. Spray a small amount of water or cleaner onto a clean lint-free cloth or paper towel.
IMPORTANT
o
Acceptable cleaners include water, Windex glass cleaner and isopropyl alcohol.
o
Starting at the corners, wipe inwards to avoid wiping dry erase residue and dust onto
the corner sensors
2. Using a clean, moistened lint-free cloth, gently wipe the corner sensors at the bottom of the
capture board. Ensure the frame and corner sensors are free of dust and residue.
Cleaning the eraser
The eraser can be used to erase ink from the capture board surface. Over time, the eraser felt
collects dry erase ink residue and becomes less effective at erasing.
To clean the eraser felt
1. Rinse the eraser felt under cold running tap water.
2. While wearing gloves, apply a mild soap or detergent and rub the eraser felt with your fingers.
3. Rinse the eraser felt thoroughly under cold running tap water
4. Remove excess water by pressing the felt against a towel or paper towel.
5. Allow the eraser felt to air dry completely.
Transporting the capture board
Save the original packaging to repack the capture board if needed. This packaging was designed
with optimal shock and vibration protection. If the original packaging isn’t available, you can
purchase the same packaging directly from your authorized SMART reseller.
CAUTION
Transport the capture board only in original or replaced packaging. Transporting the capture
board without correct packaging voids the warranty and could lead to product damage.
Replacing the markers and eraser
The SMARTkapp 42" capture board comes with three dry erase markers and one eraser.
The SMARTkapp 84" capture board comes with six dry erase markers and one eraser.