Computer Monitor User Manual
Table Of Contents
- Cover page
- Important information for your interactive flat panel
- Chapter 1: About your interactive flat panel
- Chapter 2: Installing your interactive flat panel
- Chapter 3: Connecting computers and peripheral devices
- Chapter 4: Installing SMART software
- Chapter 5: Using your interactive flat panel
- Turning on and turning off your interactive flat panel
- Understanding presence detection
- Using the infrared remote control
- Getting started with your SMART Board interactive flat panel
- Playing audio files on your interactive flat panel
- Using the USB receptacle
- Chapter 6: Using guest laptops with your interactive flat panel
- Chapter 7: Maintaining your interactive flat panel
- Updating your SMART software and firmware
- Calibrating your interactive flat panel
- Orienting your interactive flat panel
- Replacing a pen nib
- Cleaning the screen
- Cleaning the presence detection sensors
- Cleaning the camera windows and reflective tape
- Maintaining ventilation
- Preventing condensation
- Checking the interactive flat panel installation
- Removing your interactive flat panel
- Transporting your interactive flat panel
- Chapter 8: Troubleshooting for your interactive flat panel
- Appendix A: Adjusting video settings with the on-screen display menu
- Appendix B: Hardware environmental compliance
- Index
Disabling the USB receptacle on the side
terminal panel
You can connect a USB drive or other USB device to the USB receptacle on the side terminal panel
of your interactive flat panel, and then access the device from computer 1. For more information, see
Using the USB receptacle on page 46.
You can also disable this USB receptacle so that it doesn’t access any of the computers connected
to your interactive flat panel.
C A U T I ON
Disconnect the power supply for your interactive flat panel before you disable the USB receptacle.
g To disable the USB receptacle
1.
Locate the rectangular cut-out on the back of your interactive flat panel.
2.
Remove the screw securing the cut-out with a Phillips screwdriver. Retain the screw and cut-
out.
3. Locate the black jumper on the circuit board inside the panel.
C H A P T E R 3
Connecting computers and peripheral devices
20