Whiteboard Accessories User Manual

These commands inform you of the current system settings. These commands are available even
when the projector is in Standby mode.
Command Response
get lamphrs lamphrs=[current lamp hours of operation]
get syshrs syshrs=[current projector hours of operation]
get fwverddp fwverddp=[current projector firmware version]
get fwvernet fwvernet=[current network firmware version]
get fwvermpu fwvermpu=[current processor firmware version]
get fwverecp fwverecp=[current ECP firmware version]
get vgaoutnetenable vgaoutnetenable=[current]
get signaldetected signaldetected=[true or false]
get usb1source usb1source=[Video source associated with the USB 1 connector on
the ECP]
get usb2source usb2source=[Video source associated with the USB 2 connector on
the ECP]
These commands control the current system settings. These commands are unavailable when the
projector is in Standby mode. See Value-based command methods on page 74 for setting absolute
and adjustment commands.
Command Command target range Response
set autosignal [target] =on
=off
autosignal=[target]
set lampreminder [target] =on
=off
lampreminder=[target]
set highbrightness [target] =on
=off
highbrightness=[target]
set autopoweroff [value] =0 to =240 autopoweroff=[value]
set zoom [value] =0 to =30 zoom=[value]
set projectorid [value] =0 to =99 projectorid=[value]
set hposition [value] =0 to =100 hposition=[value]
set vposition [value] =-5 to =5 vposition=[value]
set aspectratio [target] =fill
=match
=16:9
aspectratio=[target]
set projectionmode [target] =front
=ceiling
=rear
=rear ceiling
projectionmode=[target]
A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
82