User's Manual
Table Of Contents
- Product Registration
- Important Information
- Contents
- About SMART Response
- Installing SMART Response
- Managing SMART Response
- Managing Class Lists
- Connecting and Disconnecting the Clickers
- Using SMART Response
- Using SMART Notebook to Ask Questions and Create Assessments
- Question Types
- Asking Questions with SMART Notebook
- Adding Questions with the Insert Question Wizard
- Creating Assessments
- Tagging questions
- Adding a Content Page
- Importing Questions from a Microsoft Word Document
- Importing Questions from XML or SQZ Files
- Importing Questions from a PDF File
- Printing from SMART Notebook Software’s Response Menu
- Exporting Results to an Excel, HTML or CSV File
- Using SMART Response Software in the Classroom
- Maintaining SMART Response
- Hardware Environmental Compliance
- Waste Electrical and Electronic Equipment Regulations (WEEE Directive)
- Restriction of Certain Chemicals (REACH Directive)
- Restriction of Certain Hazardous Substances (RoHS Directive)
- Batteries
- Packaging
- Covered Electronics Devices
- China’s Electronic Information Products Regulations
- U.S. Consumer Product Safety Improvement Act
- Customer Support
Chapter 5
Connecting and
Disconnecting the Clickers
Connecting Clickers in Anonymous Mode
NOTE
• If the teacher selected the Lock Sign In option, the clicker turns off.
• When all of your students are connected, you can start asking questions.
Connecting the Clickers in Sign In Mode
NOTE
In this mode, students must know the classroom name. They must also sign in
with a unique ID number, either with the ID you assigned to them when you
created the class list, or unassigned ID.
When the “SMART Response is ready to use” balloon message appears, tell your
students to follow these steps.
To connect clickers in
Sign in mode
1. Press the clicker’s Power button for one second.
2. A message appears asking if you want to join the last class the clicker was
connected to, or find a different class.
3. Press Enter to join the last class.
OR
Press Down to select Find a class, and then press Enter.
The clicker scans for classes, and then displays a list of classes within range.
4. Press the Up and Down buttons to select the correct class, and then press Enter.
A connecting message appears, followed by a message asking for an ID number.